Liebert 30-130kVA Operation And Maintenance Manual page 93

Table 7 Alarms, functions, and corrective actions (continued)
Actual
Alarm/fault
Name
Displayed Description
On Front of Alarm/
Panel Fault
System Fan System Fan
Fail Fail
EPO Latched EPO Latched
SBS
SBS Unable
Unable
Transfer To Transfer To
Byp OK Bypass OK
Reduced
Low batt
Battery
capacity
Capacity
Inv Off by
Inv Off by User Alarm
User
Batt Low Battery Low
Warning Warning
Batt Test Battery Test
Failed Failed
Batt Test Battery Test
Passed Passed
Config Config
Modified Modified
Fault
Or Latch Dial Freeze
Alarm Mask Mask Mask
Alarm NO YES
Alarm NO NO
Alarm NO NO
Alarm YES YES
Alarm YES YES
YES YES
Alarm YES YES
Alarm YES YES
Alarm NO NO
Alarm NO NO
Event Log
Mask Meaning and Corrective Action(s)
A fault in the designated Fan motor has
occurred. This condition only causes an
alarm, but if not promptly corrected it could
cause an equipment over-temperature
NO YES
condition that would shut down the UPS
Module. Check the Fans for proper
operation. Contact Liebert Global Services
to replace a fan.
During start up the EPO switch is sensed as
being activated. Startup is inhibited until the
NO YES alarm is cleared. Clear the latched EPO via
the push-button switch located on the
SWGR Board, then perform start up.
The UPS output is not synchronized to the
bypass power source, the static bypass
switch is disconnected, or it has failed
internally. Emergency and overload transfer
to the bypass source is not available. If the
NO YES module does not have a manual disconnect
switch, open and re-close the static switch
fuseholder. If the alarm conditions are
automatically corrected, reset the alarm to
clear it. Contact Liebert Global Services if
the alarm stays on.
Shows after a successful transfer to
NO YES
Bypass. Display is only momentary.
Occurs on systems with multiple battery
cabinets. Indicates that at least one battery
breaker is on and one or more battery
NO YES breakers in the string are off. In this state,
the calculations for battery time remaining
and End of Discharge are adjusted
accordingly.
The User has turned the inverter off through
NO YES the front panel. Puts data into the event
history log.
With the battery breaker closed, the UPS
has determined that the DC bus voltage
has reached the user settable "Battery Low
NO YES Warning" set point. Complete the controlled
shutdown of the critical load. Reset the
alarms if the input power is restored before
shutdown.
With the battery breaker closed, the battery
NO YES has failed the self-test. Momentary display.
Sets flag in the event history log
With the battery breaker closed, the battery
NO YES has passed the self-test. Momentary
display. Sets flag in the event history log
The User has modified and saved one or
more settings on the configuration screen.
NO YES
Momentary display. Sets flag in the event
history log
85
Operation