Trouble Messages - ADT Safewatch QuickConnect Plus User Manual

SYSTEM FUNCTIONS

Trouble Messages

Typical Trouble Condition Displays
To silence the beeping sound for fault conditions, press any key.
Fault
Fault 103
FC
CC
dI
bF
CA Alarm Cancelled
EA Exit Error
90
Low Bat
(no zone no.)
Low Bat
(with zone no.)
Low Bat
(with zone 00)
† Notify your service company.
Indicates that a problem exists with the zone(s) displayed, accompanied by
rapid beeping. First, determine if the zone(s) displayed are intact and make
them so if they are not. If the zone uses a wireless detector, check that changes
in the room (moving furniture, televisions, etc.) are not blocking wireless
signals from the detector. If the problem has been corrected, the zone
descriptor(s) and Fault should disappear from the display. If not, key an OFF
sequence (security code plus OFF) to clear the display. A fault condition can
also indicate a wiring problem. If the "FAULT" display persists, notify your
service company. Note that the system will not allow arming if a fault
condition exists. To arm the system with a fault condition present, you must
first bypass the zone(s) having the fault condition.
Indicates an ECP communications/supervision failure, case tamper or low
battery.
Indicates that a failure has occurred in the telephone communication portion
of your system or a problem with the phone line existed when dialing was
attempted.†
Indicates that the control is on-line with the central station's remote
computer. The control will not operate while on-line. Wait a few minutes. The
display should disappear.
If this remains displayed for more than 1 minute, the system is disabled. †
Indicates backup LRR/GSM/IP module communication failure
(displayed on RF Keypad only)
Indicates a cancelled alarm. See Entry/Exit Delay section
Indicates an exit alarm. See Entry/Exit Delay section.
Indicates that the system has detected an RF jam condition or excessive
interference. If the condition persists, notify your service company.
Accompanied by a once-per 45 seconds beeping at the keypad, indicates a low
system battery condition exists. Refer to the Changing the
QuickConnect Plus
Security System Battery section.†
Accompanied by a once-per-45 seconds beeping at the keypad, indicates a low
battery condition exists in the wireless transmitter displayed.†
Accompanied by a once-per-45 seconds beeping at the keypad, indicates a low
battery condition exists in a wireless keypad.†
– 34 –

ADT Safewatch