Trouble Conditions; Check" And "Battery" Displays - ADT SA10ADTEG User Manual

T
"Check" and he word CHECK on the touchpad's display, accompanied by a "beeping" at the
"Battery" Displays touchpad, indicates a trouble condition in the system.
To silence the beeping for these conditions, press any key.
1. A display of "CHECK" and one or more zone numbers indicates that a
2. If there are wireless sensors* in your system, the CHECK condition may
* Not all systems use
wireless sensors.
IF YOU CANNOT CORRECT A "CHECK" DISPLAY, CALL FOR SERVICE AT ONCE.
06
CHECK
ENGLISH DISPLAY TOUCHPAD
See the Limited Warranty statement on page 42 for information on how to obtain service.

TROUBLE CONDITIONS

problem exists with the displayed zone(s) and requires your attention. Determine if
the zone(s) displayed are intact and make them so if they are not. If the problem has
been corrected, the display can be cleared if you enter the OFF sequence (security
code plus OFF key) twice. If the display persists, CALL FOR SERVICE .
Note: A display of CHECK 70 on English Display touchpads indicates that the
wiring connection to the external sounder is at fault (opened or shorted), and you
should CALL FOR SERVICE. See "BELL FAILURE" on next page.
also be caused by some change in the environment that prevents the receiver from
hearing a particular sensor. CALL FOR SERVICE if this occurs.
TYPICAL "CHECK" DISPLAYS
AC
– 26 –
CHECK 06
BE DROOM WINDOW
CUSTOM ENGLISH DISPLAY