Table of Contents
Advertisement
diagonal slots in the fixed part of the wick adjuster, and 3) the slots in the moving part of the wick adjuster controlled by
the wick adjuster knob.
6. Fold the new wick in quarters and insert it into the wick adjuster from wickadjuster bottom. Place one of the pins in one of
the lined-up openings. lf you experience difficulty, gently turn the wick adjuster knob clockwise. Then insert the two other
pins, turning the wick adjuster knob if necessary. Do not bend the sleeve.
7. Finally, gently press the wick, all along its circumference, against the adjusterto insure that it is firmly in place.
8. Lower the wick adjuster into the fuel tank, guiding the tail of the wick so it fitsover the primary air tube and evenly into
place.
Point the wick adjuster knob to the front of the heater. Insure that the wick adjuster is centered over the studs on the fuel
tank.
NOTE: The space between the wick adjuster and the primary air tube should be even all around.
NOTE: Make certain the top of the wick adjuster and the top of primary air tube are the same height. lf they are uneven,
the flames tend to be uneven, too.
9. Tighten the four (4) wing nuts around the wick adjuster.
10. Turn the wick adjuster knob to be sure the wick moves smoothly up and down.
AFTER REPLACING THE WICK, CHECK THE OPERATlON OF THE AUTOMATlC EXTINGUISHER.
Wick height on position 1 of the wick life extender should be 8mm when wick adjuster knob is
turned fully cIockwise. Be sure to check.
NOTE:
Remember always to start a new wick on position 1 of the wick life extender.
Advertisement
Table of Contents
