Table of Contents
Advertisement
3. CHECK THE WICK LIFE EXTENDER
On your first use of new heater or after replacing the wick, check if the WICK LIFE EXTENDER if it
on position 1. If not, relocate the WICK LIFE EXTENDER to position 1 by following the instructions
on page 9, ADJUSTMENT OF WICK HEIGHT WITH WICK LIFE EXTENDER.
4. ENGAGE THE AUTOMATIC EXTINGUISHER
The automatic extinguisher is engaged automatically by turning the wick adjuster knob clockwise.
Check the operation of the automatic extinguisher before lighting your heater. After turning the
wick adjuster knob clockwise until it stops, turn the manual shutoff counterclockwise to be sure
the wick moves smoothly down.
LIGHTING
NOTE: When you first use your new heater, ignite it out of the living area of your house, either in a
garage or an outside area protected from strong drafts. Burn it for about 15 minutes to remove all of the protective
oil present on the burner parts. lf this 15 minutes "burn-in" is done inside, some objectionable odor will be observed.
This procedure is necessary ONLY THE FIRST TIME you ignite your heater.
Advertisement
Table of Contents
