Table of Contents
Advertisement
1. REMOVE PACKING MATERIALS
Remove all packing materials from your heater and install the guard as follows:
CAUTION: Risk of burns. Do not operate heater without guard completely attached.
a) Remove the carrying handle, top plate and packing materials.
b) Replace the top plate and install carrying handle by inserting end of carrying handle to the guard
as per illustration.
2. lNSTALL DRIP TRAY
NOTE: DO NOT operate your heater without the drip tray.
Place the drip tray on the floor.
Place the heater on the drip tray.
Turn the heater clockwise until the feet slide into their tabs.
3. CHECK SCREWS
Make sure that the three (3) screws around the guard above the fuel tank are tight.
4. INSTALL BATTERIES
Insert the two (2) C size batteries according to the plus (+) and minus (-) markings inside the holder.
FUELING
WARNING:
Use only clean Kerosene (paraffin).
Never use gasoline (petrol) or other flammable liquids.
ALWAYS extinguish heater before refill heater fuel tank. Fuel heater
outside the living area.
1. lnsert the straight tube of the manual fuel siphon into the kerosene (paraffin) container. Remove the fuel tank cap on the
heater, and insert the siphon's flexible hose into the fuel tank opening.
USE KEROSENE ONLY
(PARAFFIN)
Advertisement
Table of Contents
