Related Manuals for E-FLITE Hurricane 25e TM
Summary of Contents for E-FLITE Hurricane 25e TM
- Page 1 Hurricane 25e ® Assembly Manual Montageanleitung Manuel d’assemblage Manuale di montaggio...
-
Page 2: Notice
This model damage, and serious injury OR create a high preinstalled, as well as an E-flite 3S 3200 mAh 30C is controlled by a radio signal subject to interference probability of superficial injury. -
Page 3: Table Of Contents
EFLC3010 2–3S Li-Po Balancing Charger EFL297519 Retract Wire Struts EFLR7140 13 g Sub-Micro Servo EFLG304 2 5–46 Adjustable Axles (not for Hardware/Accessory Sizes use with EFL297519) Main wheel diameter 3-in (76mm) Tail wheel diameter 1.125-in (28mm) Wing bolt 3mm x 15mm E-flite Hurricane 25e PNP/BNF Assembly Manual... -
Page 4: Required Tools And Adhesives
• Never discharge Li-Po cells to below 3V under load. • Never cover warning labels with hook and loop strips. • Never leave charging batteries unattended. • Never charge batteries outside safe temperature range. • Never charge damaged batteries. E-flite Hurricane 25e PNP/BNF Assembly Manual... -
Page 5: Propeller Removal And Installation - Bnf/Pnp
Balancing prolongs the life of the battery. 8. When the battery is fully charged, there will be an audible beep for about 3 seconds, and the green LED will shine continuously. E-flite Hurricane 25e PNP/BNF Assembly Manual... -
Page 6: Battery Installation - Bnf/Pnp
4. Remove the propeller from the motor adapter. Do not connect the lead from the battery to the speed control until instructed to do so. E-flite Hurricane 25e PNP/BNF Assembly Manual... -
Page 7: Transmitter And Receiver Binding - Bnf
4. Install a bind plug in the receiver’s bind port. 5. Connect the flight battery to the ESC. 6. Power on the ESC switch. The receiver LED will begin to flash rapidly under the rear hatch. E-flite Hurricane 25e PNP/BNF Assembly Manual... - Page 8 6. Slide the stabilizer in position as shown in step preventing them from seating fully. 2. Apply a small amount of epoxy to the end of the stabilizer tube and in the stabilizer as shown in step 4. Slide the remaining stabilizer into position. E-flite Hurricane 25e PNP/BNF Assembly Manual...
-
Page 9: Main Gear Installation - Bnf/Pnp
3. Use four 2.5mm x 12mm self-tapping screws 5. Repeat steps 1 through 4 to install the remaining to secure the landing gear mount cover. Use a #1 landing gear assembly. Phillips screwdriver to tighten the screws. E-flite Hurricane 25e PNP/BNF Assembly Manual... -
Page 10: Optional Retract Installation - Bnf/Pnp
Please order part number EFL297519. Always use threadlock on metal-to-metal fasteners to prevent them from vibrating loose. E-flite Hurricane 25e PNP/BNF Assembly Manual... - Page 11 Take your time and ensure that this is perfect. Reinsert the strut into the retract unit and tighten the setscrew in the unit to lock the strut into place. E-flite Hurricane 25e PNP/BNF Assembly Manual...
- Page 12 This will keep the axle from rotating when flying from grass 12. Use the transmitter to retract the gear. Check runways or during rough landings. that the wheel is centered in the wheel well. Adjust the axle as necessary using a 2.5mm hex wrench. E-flite Hurricane 25e PNP/BNF Assembly Manual...
-
Page 13: Flap Linkage Installation - Bnf/Pnp
19. Repeat steps 1 through 18 to install the remaining retract assembly. E-flite Hurricane 25e PNP/BNF Assembly Manual... -
Page 14: Joining The Wing Panels - Bnf/Pnp
Before joining the wing panels, we highly recommend in flight. You will note the inner flap travels slightly test fitting all parts before mixing epoxy. If the epoxy begins to cure before parts are assembled, it will be further down than the outer flap. This is normal. difficult to reuse items where epoxy has been applied. E-flite Hurricane 25e PNP/BNF Assembly Manual... - Page 15 3. Separate the wing panels and remove the fiberglass wing tube. Mix .50 ounce (15mL) of 30-minute epoxy. Apply epoxy to the fiberglass wing tube and into both of the sockets in the wing panels. E-flite Hurricane 25e PNP/BNF Assembly Manual...
-
Page 16: Receiver Installation - Pnp
CAUTION: The installation of the foam radiator scoop and bolt plates on the wing are integral parts of joining the wing properly. Make sure these items are glued securely to the wing to prevent wing failure. E-flite Hurricane 25e PNP/BNF Assembly Manual... -
Page 17: Wing Installation - Bnf/Pnp
3. Connect the aileron and flap (and optional retract) leads to the appropriate Y-harness at the 6. The shorter antenna is routed to the front of the receiver. fuselage. There is no need to tape it in position. E-flite Hurricane 25e PNP/BNF Assembly Manual... -
Page 18: Center The Control Surfaces - Bnf/Pnp
Remove the antenna mast during transport or when working on your model so it does not get lost or damaged. 4. Place the canopy hatch on the fuselage. E-flite Hurricane 25e PNP/BNF Assembly Manual... -
Page 19: Center Of Gravity
2. When balancing your model, support the plane inverted at the marks made on the top of the wing with your fingers or a commercially available balancing stand. This is the correct balance point E-flite Hurricane 25e PNP/BNF Assembly Manual... -
Page 20: Preflight
We highly recommend re-binding the radio system once all the control throws are set. This will keep the servos from moving to their endpoints until the transmitter and receiver connect. E-flite Hurricane 25e PNP/BNF Assembly Manual... -
Page 21: Daily Flight Checks
877.504.0233 toll free to speak to a Product Support a hot, enclosed area such as a car. Doing so EXCLUSIVE REMEDY. representative. You may also find information on our can damage the foam. website at www.horizonhobby.com. E-flite Hurricane 25e PNP/BNF Assembly Manual... - Page 22 61822 USA date. Provided warranty conditions have been met, productsupport@horizonhobby.com your Product will be serviced or replaced free of 877-504-0233 charge. Service or replacement decisions are at the sole discretion of Horizon. E-flite Hurricane 25e PNP/BNF Assembly Manual...
-
Page 23: Compliance Information For The European Union
May 26, 2011 Champaign, IL USA Mar 15, 2011 Steven A. Hall Steven A. Hall Vice President International Operations and Risk Management Vice President Horizon Hobby, Inc. International Operations and Risk Management Horizon Hobby, Inc. E-flite Hurricane 25e PNP/BNF Assembly Manual... -
Page 24: Academy Of Model Aeronautics National Model Aircraft Safety Code
Person View (FPV) only in accordance with the could adversely affect the pilot’s ability to safely procedures outlined in AMA Document #550. control the model. E-flite Hurricane 25e PNP/BNF Assembly Manual... - Page 25 50 feet to any above-ground electric utility lines. 5. The flying area must be clear of all nonessential participants and spectators before the engine is started. E-flite Hurricane 25e PNP/BNF Assembly Manual...
- Page 26 The Spektrum trademark is used with permission of Bachmann Industries, Inc. E-flite, JR SPORT, DSM, DSM2 and UltraCote are trademarks or registered trademarks of Horizon Hobby, Inc. All other trademarks, service marks and logos are the property of their respective owners.