Wep Encryption - ZyXEL Communications NBG6503 User Manual

The following table describes the labels in this screen.
Table 32 Network > Wireless LAN 2.4G/5G > Security: No Security
LABEL
SSID
Security Mode
Apply
Cancel
Refer to Table 31 on page 82

10.5.2 WEP Encryption

WEP encryption scrambles the data transmitted between the wireless stations and the access points
to keep network communications private. It encrypts unicast and multicast communications in a
network. Both the wireless stations and the access points must use the same WEP key.
Your NBG allows you to configure up to four 64-bit or 128-bit WEP keys but only one key can be
enabled at any one time.
In order to configure and enable WEP encryption, click Network > Wireless LAN 2.4G or
Wireless LAN 5G to display the General screen. Select Static WEP from the Security Mode list.
Figure 63 Network > Wireless LAN 2.4G/5G > Security: Static WEP
Chapter 10 Wireless LAN
DESCRIPTION
Select the wireless network identified by this SSID to which to apply the following Security
Mode.
Choose No Security from the drop-down list box.
Click Apply to save your changes back to the NBG.
Click Cancel to reload the previous configuration for this screen.
for descriptions of the other labels in this screen.
NBG6503 User's Guide
84