Table 15 Network Setting > Wireless > General (continued)
LABEL
BSSID
Security Level
Security Mode
Apply
Cancel
7.2.1 No Security
Select No Security to allow wireless stations to communicate with the access points without any
data encryption or authentication.
Note: If you do not enable any wireless security on your VMG, your network is accessible
to any wireless networking device that is within range.
Figure 31 Wireless > General: No Security
The following table describes the labels in this screen.
Table 16 Wireless > General: No Security
LABEL
Security Level
7.2.2 Basic (WEP Encryption)
WEP encryption scrambles the data transmitted between the wireless stations and the access points
(AP) to keep network communications private. Both the wireless stations and the access points
must use the same WEP key.
Chapter 7 Wireless
DESCRIPTION
This shows the MAC address of the wireless interface on the VMG when wireless LAN is
enabled.
Select Basic (WEP, 802.1X) or More Secure (WPA(2)-PSK) to add security on this
wireless network. The wireless clients which want to associate to this network must have
same wireless security settings as the VMG. When you select to use a security, additional
options appears in this screen.
Or you can select No Security to allow any client to associate this network without any data
encryption or authentication.
See the following sections for more details about this field.
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
DESCRIPTION
Choose No Security to allow all wireless connections without data encryption or
authentication.
VMG8924-B10A and VMG8924-B30A Series User's Guide
104