Table of Contents
Advertisement
Connecting the Monitors
The number of monitors that you can connect to the MAXPRO NVR unit varies based on the
NVR Edition you purchase. Refer to the
Powering on the MAXPRO NVR Unit
This section describes the steps to power on the MAXPRO NVR unit.
To power on the MAXPRO NVR unit
1.
2.
3.
To turn off the power for MAXPRO NVR
1.
2.
Changing the MAXPRO NVR IP Address and
Machine Name
Your MAXPRO NVR unit has pre-configured network ports with the following default IP
addresses.
MAXPRO NVR Commissioning and Installation Guide
Note:
Honeywell recommends using an Uninterrupted Power Supply (UPS) for the
MAXPRO NVR unit and the cameras. Powering the cameras and unit from a UPS
ensures that the MAXPRO NVR unit can continue to record video during a power
outage. If you need to monitor video during a power outage, consider a UPS for
the client workstations as well.
Turn on camera(s) and other hardware connected to the MAXPRO NVR unit.
Press and hold the power button on front of the MAXPRO NVR unit. The power button
turns "blue" after the MAXPRO NVR unit is turned on.
After powering on the unit, you are prompted to log on. The default user is user name:
Administrator, password: Password1. The user name and password are case sensitive.
After logging in, the MAXPRO NVR Wizard automatically starts up.
Note:
•
You can change the default password, Password1, see the
default Windows Password on MAXPRO NVR
•
Refer to the
MAXPRO NVR Operator's Guide
MAXPRO NVR Wizard.
Close the MAXPRO NVR application.
Click Start>Shut Down. Wait for the MAXPRO NVR unit to shut down.
•
192.168.1.101 for NIC1 (Camera Network)
•
172.25.254.101 for NIC2 (Client Workstation Network)
S E T T I N G U P T H E M A X P R O N V R
Settings for the MAXPRO NVR Single-box Turnkey Solution
MAXPRO NVR Data Sheet
section for more information.
for more information on the
for more information.
Changing the
23
Advertisement
Table of Contents
