Unified Access Point Administrator's Guide
Note: After you configure the SNMPv3 Users settings, you must click Apply to apply the changes
and to save the settings.
Configuring SNMPv3 Targets
SNMPv3 Targets send "inform" messages to the SNMP manager. Each target is identified by a target name and
associated with target IP address, UDP port, and SNMP user name.
Field
IPv4/IPv6 Address
Port
Users
SNMPv3 Targets
Note: After you configure the SNMPv3 Target settings, you must click Apply to apply the changes
and to save the settings.
January 2015
Figure 43 - SNMPv3 Targets Configuration
Description
Enter the IP address of the remote SNMP manager to receive the target.
Enter the UDP port to use for sending SNMP targets.
Select the name of the SNMP user to associate with the target. To configure SNMP users,
see
"Configuring SNMPv3 Users" on page 77.
This field shows the SNMPv3 Targets on the UAP. To remove a target, select it and click
Remove.
Table 46 - SNMPv3 Targets
Section 6 - Configuring SNMPv3
Unified Access Point Administrator's Guide
Page 78