Section 4 - Managing The Access Point; Ethernet Settings; Figure 16 - Modify Ethernet (Wired) Settings; Table 22 - Virtual Access Point Settings - D-Link DWL-2600AP Administrator's Manual

Unified Access Point Administrator's Guide

Section 4 - Managing the Access Point

This section describes how to manage the UAP and contains the following subsections:
•) "Ethernet Settings" on page 35
•) "Wireless Settings" on page 37
•) "Modifying Radio Settings" on page 40
•) "Configuring Radio and VAP Scheduler" on page 44
•) "Scheduler Association Settings" on page 46
•) "Virtual Access Point Settings" on page 47
•) "Configuring the Wireless Distribution System (WDS)" on page 56
•) "Controlling Access by MAC Authentication" on page 58
•) "Configuring Load Balancing" on page 60
•) "" on page 60
•) "Configuring 802.1X Authentication" on page 62
•) "Creating a Management Access Control List (ACL)" on page 63
The configuration pages for the features in this section are located under the Manage heading on the Administration
Web UI.

Ethernet Settings

The default wired interface settings, which include DHCP and VLAN information, might not work for all networks.
By default, the DHCP client on the UAP automatically broadcasts requests for network information. If you want to
use a static IP address, you must disable the DHCP client and manually configure the IP address and other network
information.
The management VLAN is VLAN 1 by default. This VLAN is also the default untagged VLAN. If you already have
a management VLAN configured on your network with a different VLAN ID, you must change the VLAN ID of the
management VLAN on the AP.
To configure the LAN settings, click the Ethernet Settings tab.
The following table describes the fields to view or configure on the Ethernet Settings page.
January 2015

Figure 16 - Modify Ethernet (Wired) settings

Section 4 - Managing the Access Point
Unified Access Point Administrator's Guide
Page 35