Powering The Access Point; Configuring The Access Point - D-Link DBA-1520P Quick Installation Manual

Powering the Access Point

The DBA-1520P can be powered using one of the
following two methods:
Using Power over Ethernet (PoE)
1. Use a standard Ethernet cable to connect the LAN
port on the DBA-1520P to a PoE power source
device such as a PoE switch or PoE injector.
(Optional) Using the power adapter
1. Connect the power connector of the adapter to
the power input on the DBA-1520P and plug the
adapter into a nearby power outlet.

Configuring the Access Point

Using D-Link Nuclias
Note: To use D-Link Nuclias, the DBA-1520P must be
connected to the Internet.
The DBA-1520P is designed to be managed through
the D-Link Nuclias cloud. Refer to the D-Link Nuclias
User Manual for detailed configuration instructions.
D-Link Nuclias
Switch or Router
DBA-1520P
Figure 3: Connecting through D-Link Nuclias
1. On an Internet-connected PC, open a web
browser and go to www.nuclias.com.
DBA-1520P
2. Enter your D-Link Nuclias user name and
password.
If a device's login credentials are modified using
Switch or Router
DBA-1520P
Nuclias Cloud, the local username and password
will also reflect the changes made. To learn more
about configuring your password, please refer to
the Nuclias Cloud manual.
DBA-1520P
Manual Configuration
6
Note: D-Link recommends manually configuring the
device before mounting it.
If you are unable to connect to the D-Link Nuclias
cloud, you may need to manually configure the
DBA-1520P using its web user interface (UI). Refer to
the Nuclias Cloud Manual for detailed configuration
instructions.
Switch or Router
Management
Management
Management
Management
D-Link DBA-1510P Quick Install Guide
Use one of the following methods to access the web
user interface:
Connecting through Ethernet
Note: The management PC must be in the same
subnet as the DBA-1520P.
1. Use an Ethernet cable to connect the DBA-1520P
to the management PC or to the switch or router
the management PC is connected to.
2. Open a web browser and type in the default
host name of the DBA-1520P and press Enter.
The default host name is DBA-1520P-XXXX
where XXXX represents the last 4 characters
of the MAC address listed on the device label
located on the bottom of the device.
3. When prompted, enter the default login
credentials:
User name: admin
Password: admin
Connecting wirelessly
1. Connect the management PC to the default SSID
of the DBA-1520P. The SSID will be in the format
DBA-1520P-XXX where XXXX represents the
last 4 characters of the MAC address listed on the
device label located on the bottom of the device.
2. Open a web browser and type in the default
host name of the DBA-1520P and press Enter.
The default host name is DBA-1520P-XXXX
where XXXX represents the last 4 characters
of the MAC address listed on the device label
located on the bottom of the device.
3. When prompted, enter the default login
credentials:
User name: admin
Password: admin
Attaching the Rubber Pads
The included rubber pads can be placed on the
bottom of the device to prevent the device from
damaging the surface it is placed on.
1. Remove the rubber pads from the adhesive strip.
2. Stick one pad on each foot on the bottom panel
of the access point.
3