Figure 32 - Configure Management Access Control Parameters; Table 35 - Management Acl - D-Link DWL-2600AP Administrator's Manual

Unified Access Point Administrator's Guide
To create an access list, click the Management ACL tab.
Field
Management ACL
Mode
IP Address (1–5)
IPv6 Address (1–5)
Note: After you configure the settings, click Apply to apply the changes and to save the settings.
January 2015

Figure 32 - Configure Management Access Control Parameters

Description
Enable or disable the management ACL feature. At least one IPv4 address should be
configured before enabling Management ACL Mode. If enabled, only the IP addresses you
specify will have Web, Telnet, SSH, and SNMP access to the management interface.
Enter up to five IPv4 addresses that are allowed management access to the AP. Use
dotted-decimal format (for example, 192.168.10.10).
Enter up to five IPv6 addresses that are allowed management access to the AP. Use the
standard IPv6 address format (for example 2001:0db8:1234::abcd).

Table 35 - Management ACL

Section 4 - Managing the Access Point
Unified Access Point Administrator's Guide
Page 64