Things To Do Before Calling The Authorized Service - Beko WKE 13580 D Manual

Things to do Before Calling the Authorized Service

If the light of the 1st auxiliary function
on the left hand side is flashing
If the cover and washing light on the
program follow-up indicator is
flashing and the end light is
constantly on
If the light of Start/Pause/Cancel
button starts to flashing after a short
time you start your machine
If the "Washing" light on the program
follow-up indicator is flashing
If the program can not be started or
selected
If the water is cut while your machine
is operating, the current program
does not proceed. To continue the
program
Your machine may stop due to the
low voltage
During the production, some water
may have remained in your machine
because of the quality control
processes.
You have selected the program
in your machine and pressed the
"Start/Pause/Cancel" button but the
machine did not start
Is water coming from under your
machine
Is the water drained directly?
During the water drainage, you may
hear water sound from the pump
Is foam running over the detergent
drawer?
If sometimes you are not satisfied
with the rinsing and spinning
efficiency (laundries have
detergent remnants or they are not
dry enough)?
It is in the child-lock mode. (See. Child-lock)
The program selection knob may be in-between
position.
Readjust the program by turning the program
selection knob. If the warning continues, contact
the authorized service.
The door is unlocked. Open and close the door
again and restart the washing program.
The water may be cut or the taps may be closed.
Check the taps. Turn off your machine and restart.
If the fault persists, unplug your machine, close the
taps and contact the authorized service.
Machine may be in the self-protection mode due to the
substructure problems (grid voltage, water pressure
and etc.)
Therefore, you can not start or select a program. Press
Start/Pause/Cancel button for 3 seconds and return
the machine to the factory settings. (See.Cancelling a
Program)
Press "Start/Pause/Cancel" button, program will
proceed.
Wait for a while. When the voltage reaches to a
normal level your machine will start to operate.
This does not cause any damage to your machine.
The plug of your machine may not be plugged in a
grounded outlet, front cover may not be closed or
the fuse may be blown.
Check the water inlet and drainage hoses. Are they
well mounted? Gaskets of the water inlet hoses
may not be well seated. If the problem is none of
them, the pump filter may not be well closed.
Check if the drainage hose is connected as
described in the user guide.
This sound is normal.
Check if your detergent is suitable for automatic
machine. Use the recommended amount of
detergent in your next washing.
Make sure that you have selected the correct
program, you have adjusted the speed adjusting/
decrease button correctly and you have loaded the
right laundries for the program you have chosen, try
again when the voltage is normal.
EN
23