Before Calling Service/Troubleshooting - Beko WMA 510 S Installation & Operating Instructions Manual

Beko automatic washing machine installation & operating instructions
Table of Contents

Advertisement

before calling service/troubleshooting

You turned the machine on, but the indicator
light is not lit
Have you plugged in and switched on at
the socket? Check the power cable, or for a
blown fuse. Check the front door is properly
closed.
After your machine starts operation, if
Start/Pause/Cancel button starts flashing then
door is not locked. Open and close the door
again and press Start/Pause/Cancel button to
begin washing program again.
Machine does not take in water
• Check the door for proper closure. Either
tap closed or water inlet filter is clogged.
• Turn the programme selector to the
programme required.
• If the "wash" led on the program progress
display and Start/Pause/Cancel button are
flashing either there is no water or tap is
off. Check your taps. Press
Start/Pause/Cancel button. If the problem
persists unplug your machine, turn off tap
water and call customer service.
Water is syphoned / discharged
Check if the drain hose is positioned as
described on page 6.
If the machine vibrates or is too noisy
• Have all the transit bolts and packing been
removed?
• Is the machine touching something?
• Are all the feet resting firmly on the ground?
• Have the lock nuts been secured?
• Has the recommended wash load been
exceeded? (See page 13 for max program
loads)
Water coming from beneath the machine
Check the water inlet and drain hoses.
Tighten the connections. The washers of the
hoses may be worn out or the pump filter may
not have been closed properly.
Foam coming out of the detergent dispenser
Check whether your detergent is suitable
for automatic machines. Next time use less
detergent.
Pump does not drain water
Check Rinse Hold button has not been
selected in error. Clean the pump filter. Do not
attempt to remove the filter if the machine is
full of water. Check whether the drain hose is
bent or not. If there is a need to clean the
pump filter, refer to the pump filter cleaning
section on page 15.
Pre-wash indicator light on the program
follower is blinking
Cancel child lock
16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wma 510 w

Table of Contents