Mercedes-Benz E-Class Coupe Operator's Manual page 98

Side windows
96
i You can start automatic operation when
opening and closing the front door windows
and when opening the rear door windows.
To do so, briefly press or pull the switch to
beyond the point of resistance in the rele-
vant direction. You can stop automatic
operation by pressing or pulling again.
i You can continue to operate the side win-
dows after you switch off the engine or
remove the SmartKey. This function is
available for up to five minutes or until the
driver's or front-passenger door is opened.
i
When the override feature for the side
windows is activated (
windows cannot be operated from the rear.
Opening and closing all side windows
(Cabriolet)
Using the switch on the center console
G WARNING
While opening the side windows, body parts in
the closing area could become trapped. There
is a risk of injury.
Make sure that no body parts are in close
proximity during the closing procedure. If
somebody becomes trapped, release the
switch or press the switch down to open the
side window again.
You can use the switch on the center console
to close all side windows simultaneously.
Open the cover in the lower center console.
X
The switch for all side windows is under the
cover.
page 70), the side
Y
To open all side windows: press
X
switch : to the point of resistance.
To open all side windows fully: press
X
switch : beyond the point of resistance.
To close all side windows: pull switch :.
X
Using the SmartKey
G WARNING
While closing the side windows, body parts in
the closing area could become trapped. There
is a risk of injury.
When closing make sure that no parts of the
body are in the closing area. If somebody
becomes trapped, release the switch or press
the switch to open the side window again.
You can use the SmartKey to open or close all
side windows simultaneously.
Close the soft top (
X
Open the trunk partition (
X
The key must be near the door handle.
X
To open all side windows: press the %
X
button on the SmartKey until the side win-
dows are fully opened.
To interrupt the opening procedure:
X
release the % button.
To close all side windows: press the
X
& button on the SmartKey until the side
windows are fully closed.
To interrupt the closing procedure:
X
release the & button.
page 101).
Y
page 107).
Y