Mercedes-Benz E-Class Coupe Operator's Manual page 303

Garage door remote control A is not inclu-
ded with the integrated garage door opener.
Turn the SmartKey to position 2 in the igni-
X
tion lock ( page 161).
Y
Select one of buttons ; to ? to use to
X
control the garage door drive.
To start programming mode: press and
X
hold one of buttons ; to ? on the inte-
grated garage door opener.
The garage door opener is now in program-
ming mode. After a short time, indicator
lamp : lights up yellow.
Indicator lamp : lights up yellow as soon
as button ;, = or ? is programmed for
the first time. If the selected button has
already been programmed, indicator
lamp : will only light up yellow after ten
seconds have elapsed.
Release button ;, = or ?. Indicator
X
lamp : flashes yellow.
To program the remote control: point
X
garage door remote control A towards
buttons ; to ? on the rear-view mirror at
a distance of 2 to 8 inches (5 to 20 cm).
Press and hold button B on remote control
X
A until indicator lamp : lights up green.
When indicator lamp : lights up green:
programming is finished.
When indicator lamp : flashes green: pro-
gramming was successful. The next step is
to synchronize the rolling code.
Release button B on remote control A for
X
the garage door drive system.
If indicator lamp : lights up red: repeat the
programing procedure for the correspond-
ing button on the rear-view mirror. When
doing so, vary the distance between remote
control A and the rear-view mirror.
The required distance between remote
control A and the integrated garage door
opener depends on the garage door drive
system. Several attempts might be neces-
sary. You should test every position for at
least 25 seconds before trying another
position.
Synchronizing the rolling code
Pay attention to the "Important safety notes"
( page 300).
Y
If the garage door system uses a rolling code,
you will also have to synchronize the garage
door system with the integrated garage door
opener in the rear-view mirror. To do this you
will need to use the programming button on
the door drive control panel. The program-
ming button may be positioned at different
locations depending on the manufacturer. It
is usually located on the door drive unit on the
garage ceiling.
Familiarize yourself with the garage door
drive operating instructions, e.g. under "Pro-
gramming of additional remote controls",
before carrying out the following steps.
Your vehicle must be within reach of the
garage door or gate opener drive. Make sure
that neither your vehicle nor any persons/
objects are present within the sweep of the
door or gate.
Turn the SmartKey to position 2 in the igni-
X
tion lock ( page 161).
Y
Get out of the vehicle.
X
Press the programming button on the door
X
drive unit.
Usually, you now have 30 seconds to ini-
tiate the next step.
Get into the vehicle.
X
Press previously programmed button ;,
X
= or ? on the integrated garage door
opener until the door closes.
The rolling code synchronization is then
complete.
Features
301
Z