Mercedes-Benz E-Class Coupe Operator's Manual page 225

side. This is meant to assist you in bringing
the vehicle back to the original lane.
If a lane-correcting brake application occurs,
display : appears in the multifunction dis-
play.
A lane-correcting brake application can be
made after driving over a lane marking rec-
ognize as being solid or broken. Before this, a
warning must be given by means of intermit-
tent vibration in the steering wheel. In addi-
tion, a lane with lane markings on both sides
must be recognized.
In the case of a broken lane marking being
detected, a lane-correcting brake application
can only be made if a vehicle has been detec-
ted in the adjacent lane. The following vehi-
cles can have an influence on brake applica-
tion: oncoming traffic, vehicles that are over-
taking and vehicles that are driving parallel to
your vehicle.
i A further lane-correcting brake applica-
tion can only occur after your vehicle has
returned to the original lane.
No lane-correcting brake application occurs
if:
you clearly and actively steer, brake or
R
accelerate.
you cut the corner on a sharp bend.
R
you have adopted a sporty driving style with
R
high cornering speeds or high rates of
acceleration.
you have switched on the turn signals.
R
a driving safety system intervenes, e.g.
R
® ®
ESP , PRE-SAFE Brake or Active Blind
Spot Assist.
®
ESP is switched off.
R
the transmission is not in position D.
R
an obstacle has been detected in the lane in
R
which you are driving.
when a loss of tire pressure or a defective
R
tire has been detected and displayed.
There is a possibility that the Active Lane
Keeping Assist could misjudge the given traf-
Driving systems
fic situation. An inappropriate brake applica-
tion may be interrupted at any time if you:
steer slightly in the opposite direction
R
switch on the turn signal
R
clearly brake or accelerate
R
A lane-correcting brake application is inter-
rupted automatically if:
a driving safety system intervenes, e.g.
R
® ®
ESP , PRE-SAFE Brake or Active Blind
Spot Assist.
lane markings can no longer be recognized.
R
Switching on Active Lane Keeping Assist
Switch on Active Lane Keeping Assist using
X
the on-board computer; to do so, select
Standard Standard or Adaptive Adaptive
If you drive at speeds above 40 mph
(60 km/h) and lane markings are detected,
the lines in the assistance graphics display
( page 235) are shown in green. Active
Y
Lane Keeping Assist is ready for use.
If Standard Standard is selected, no warning vibra-
tion occurs if:
you have switched on the turn signals. In
R
this event, the warnings are suppressed
for a certain period of time.
a driving safety system intervenes, such
R
as ABS, BAS or ESP
When Adaptive Adaptive is selected, no warning
vibration occurs if:
you have switched on the turn signals. In
R
this event, the warnings are suppressed
for a certain period of time.
a driving safety system intervenes, e.g.
R
ABS, BAS or ESP
you accelerate hard, e.g. kickdown.
R
you brake hard.
R
you steer actively, e.g. swerve to avoid an
R
obstacle or change lanes quickly.
you cut the corner on a sharp bend.
R
In order that you are warned only when nec-
essary and in good time if you cross the lane
marking, the system recognizes certain con-
ditions and warns you accordingly.
( page 236).
Y
®
.
®
.
Z
223