Mirror Print Settings; Offset - Brady BBP 33 User Manual

Mirror Print Settings

Offset

®
33 Sign & Label Printer User's Manual
BBP
Use this procedure to print labels suitable for reading in a mirror or through the
back of the label.
To set the mirror-image option:
Note: Mirror print settings are in effect only during the current print job. When
the print job is complete, the printer returns to the default setting.
1. Press to go to the navigation menu.
2. Press or to scroll to Output Settings, then press
3. Press to scroll to Mirror Print, then press
4. Press or to select On or Off.
5. Press to accept the change.
6. When done, press
Offset is a value that will move the image from its "nominal" position on the label
slightly in one direction or another. Adjusting the offset is typically used to do a
fine adjustment of the printed image on a die-cut label, or to move the image
slightly closer or further from the edge of a continuous supply.
To set the offset:
1. Press to go to the navigation menu.
2. Press or to scroll to Output Settings, then press
3. Press to scroll to Offset, then press
4. Press or to select Horizontal or Vertical, then press
5. Press or to adjust the offset:
• Horizontal: shifts the image (printed portion of the label) to the right or left
(values ± 0.01 – 0.10).
• Vertical: shifts the image (printed portion of the label) up or down
(values ± 0.01 – 0.10).
6. Press to accept the change.
7. When done, press
twice to exit to the main menu.
.
twice to exit to the main menu.
Output Settings
Offset
.
.
.
.
-
3 5