Overload Protection (Kohler-Powered Units); Servicing Optional Spark Arrestor (Kohler-Powered Units) - Hobart Champion 10,000 Owner's Manual

8-4. Overload Protection (Kohler-Powered Units)

2

8-5. Servicing Optional Spark Arrestor (Kohler-Powered Units)

1
Tools Needed:
1/4 in
OM-945 Page 30
Y Stop engine.
.
If the unit is extremely over-
loaded, weld and auxiliary pow-
er will stop. Turn unit off and re-
start to reset the generator
protection circuit and restore
weld and auxiliary power out-
put.
If the rated output of the unit is
exceeded, engine speed may
vary rapidly until the weld or
auxiliary power load is re-
duced.
1 Fuse F1 (See Parts List)
1
F1 protects the generator excitation
circuit. If F1 opens, there will be no/
low weld and auxiliary power out-
put.
2 Fuse F6 (See Parts List)
F6 protects the engine wiring
harness. If F6 opens, the engine
does not crank. If F6 opens while
the engine is running, the engine
stops.
Replace any open fuses. Reinstall
panel before operating unit.
Tools Needed:
.
If a fuse opens, it usually indi-
cates a more serious problem
exists. Contact a Factory Au-
thorized Service Agent.
3/8 in
801 226-B / Ref. 801 221-A / Ref. 183 175–A
Y Stop engine and let cool.
1 Spark Arrestor Screen
Clean and inspect screen. Replace
spark arrestor if screen wires are
broken or missing.
Ref. 801 695-A / Ref. 802 339-A