Section 7 − Maintenance &Troubleshooting; Routine Maintenance; Overload Protection; Drive Motor Protection - Hobart Handler 210 Owner's Manual

SECTION 7 − MAINTENANCE &TROUBLESHOOTING

7-1. Routine Maintenance

n = Check
* To be done by Factory Authorized Service Agent
l Unreadable Labels
Every
3
Months
nl Cords
Every
6
Months
~ Drive Rolls

7-2. Overload Protection

7-3. Drive Motor Protection

Drive motor protection circuit protects drive motor from overload. If drive motor becomes inoperative, release gun
trigger and wait until protection circuit resets allowing drive motor to feed wire again.
OM-227 978 Page 24
Z = Change ~ = Clean
~ Weld Terminals
nl Gun Cables
OR
~ Inside Unit
1
l = Replace
l Damaged Gas Hose nl Weld Cables
! Disconnect power
before maintaining.
.
Maintain more often
during severe conditions.
Reference
1 Supplementary Protector CB1
CB1 protects unit from overload. If
CB1 opens, unit shuts down.
Reset supplementary protector.
802 441