Connection; Connecting External Equipment (1) - Sony DVO-1000MD Instructions For Use Manual

Connection

Notes
• Before making connections, be sure to turn the power
of any peripheral equipment off.

Connecting External Equipment (1)

This section gives a connection example to operate the
unit connected to external equipment using a remote
control unit (not supplied) and/or foot switch (not
supplied).
Settings required for using this connection
example
Make the following settings before operating in this
connection example using SETUP MENU.
For detailed information on menu operation, see "Basic
Menu Operations" on page 50.
• Audio output selection
Select the audio output channel using the AUDIO
MON CH sub menu of SETUP MENU (see page 47).
1
S-video cable (not supplied)
2
Audio cable (not supplied) Audio cable (not supplied)
3
Audio cable (not supplied) Audio cable (not supplied)
4
AC power cord (not supplied)
Rear panel
4
to AC outlet
1
2
AUIDO IN L/R
S-VIDEO IN
- AC IN
Front panel
• Connect the AC power cord last.
– LCH: Outputs the audio signal of audio channel 1.
– RCH: Outputs the audio signal of audio channel 2.
– MIX: Outputs a mixed audio signal from both
channel 1 and channel 2. (factory setting)
• Input signal selection
Select the input signal "ANALOG" using the INPUT
SELECT sub menu of SETUP MENU (see page 24).
• Foot switch mode selection
Select the operation mode of the foot switch from
among LOW EDGE (factory setting), HIGH EDGE
and LOW ACTIVE (see page 28).
To S-video output connector
To analog audio output connector
To S-video input connector
1
S-VIDEO OUT
3
To analog audio input connector
MONITOR AUDIO
REMOTE 1
REMOTE 2
External equipment
Video monitor
SVRM-100A remote
control unit
Foot switch
13
Connection