NEC UNIVERGE SV9300 DT410 User Manual page 91

2. Connect key lamp goes off and Bluetooth function will be disabled. →
It is not possible to disable the Bluetooth function when the terminal and
smart device is in processing of pairing connection.
CONNECT WITH SMART DEVICE
The terminal can be connected with smart device which has completed pairing, automatically or manually. Only
the smart device that has been connected last can be connected through Bluetooth to the terminal.
AUTOMATIC CONNECTION
1. Confirm the Bluetooth function is on. (Connect key lamp lights red.) →
2. Place the smart device that has been connected last through Bluetooth near the
terminal. (Effective range of Bluetooth radio interface is within 10 meter from the
terminal approximately.)
3. The terminal is connected to the smart device through Bluetooth automatically.
MANUAL CONNECTION
1. Confirm the Bluetooth function is on. (Connect key lamp lights red.) →
2. Press Connect Key. (Less than 3 seconds)
3. The terminal is connected to the smart device through Bluetooth.
SWITCH TERMINAL'S HANDSET TO SMART DEVICE
When you converse with caller using terminal handset, you can switch to the smart device and continue the
conversation without disconnecting the call.
1. When you are in conversation with caller through mobile phone network, press Connect
key. (Less than 2.5 seconds)
2. Converse with caller using smart device.
If you press Connect key once again, you can return to the terminal
handset and continue conversation.
SWITCH THE MODE OF TERMINAL
When the terminal is connected with smart device though Bluetooth, the terminal mode can be switched by
pressing the Path key. (Wired Telephone Mode/ Mobile Phone Mode)
The status of the terminal mode switched by the Path key lamp is as follows.
MODE
Wired Telephone Mode
LAMP COLOR
Orange
APPENDIX C PAIRING WITH SMART DEVICE
LAMP INDICATION
(Flashing interval is
shown in seconds)
Lighting
Flashing
(0.25 ON-0.25 OFF)
84
TERMINAL STAUS
Smart device is idle or not
be connected.
Smart device is playing
music.