NEC UNIVERGE SV9300 DT410 User Manual page 17

2. At each corner, press the locking pin back into place.
Please attach the Faceplate securely. If not, the terminal will not
operate properly because a key is possibly being pushed by the
Faceplate.
ADJUSTING ANGLE OF TILT LEGS
The height can be adjusted by moving the legs attached to the bottom of the terminal.
RAISING TILT LEGS
1. Turn the terminal over (key side down).
(1)
(2)
(3)
(1) Line Key Panel
(2) Center Bar
(3) Face Plate
(4) DESI Printer Sheet
(4)
(3)
(2)
(1)
(1) First Position
(2) Second Position
(3) Third Position
(4) Forth Position
10
INTRODUCTION
(4)