Adjusting The Position; Adjusting The Display - Sony DVF-L700 Operating Instructions Manual

Adjusting the Position

You can adjust the height, orientation, and angle of the
viewfinder via the flexible arm's three joints.
Center joint
Allows you to adjust the height by changing the angle of
the arm's two poles.
Top and bottom joints (ball type)
Allows you to change the orientation via rotation, or tilt
the arm in the direction of the notches.
Notch
Note
Hold the viewfinder firmly when loosening the arm lock
knob to prevent it from dropping.
1
Turn the flexible arm's arm lock knob in the opposite
direction of LOCK to loosen it.
2
Adjust the position.
3
Turn the arm lock knob in the LOCK direction to lock
it into place.
The three joints of the flexible arm will be locked into
place.
8
Adjusting the Position / Adjusting the Display
Arm lock knob
Notch

Adjusting the Display

You can adjust the brightness, contrast, and peaking of
the display using the BRIGHT, CONTRAST, and
PEAKING buttons.
Note
When using VF mode, changing the peaking value with
the PEAKING button will not affect the display image
unless the peaking setting on the camera is enabled.
Example: Adjusting the contrast
1
Press the CONTRAST button.
The CONTRAST indicator lights, and adjustment is
enabled.
2
Change the values using the – and + buttons.
The display image changes according to the changes.
To restore the default values, press the – and
+ buttons simultaneously.
3
When you finish configuration, press the
CONTRAST button again.
The CONTRAST indicator turns off.