Parts Identification - Sony DVF-L700 Operating Instructions Manual

Parts Identification

Front
0
9
8
7
6
Rear
wj
wh
wg
wf
wd
ws
wa
a Tally indicator
Lights or blinks red or turns off according to the situation.
Lit: The camera/camcorder is recording.
Blinking: An error or warning has occurred.
For details on the status of the indicator, refer to the
operating instructions for your camera/camcorder.
b HIGH BRIGHT (high-brightness display)
indicator
Lights yellow during high-brightness display.
c BRIGHT adjustment indicator
Lights orange during brightness adjustment.
d CONTRAST adjustment indicator
Lights orange during contrast adjustment.
e PEAKING adjustment indicator
Lights orange during peaking adjustment.
4
Parts Identification
f Ventilation inlet
g POWER indicator
Lights green when power is being supplied.
h INPUT indicator
Lights green when there is a signal input. The indicator
1 blinks green when the signal format is not supported.
i SPARE indicator
2
3 Lights orange during false color display.
j FOCUS MAG (magnified display) indicator
4
Lights orange during magnified display.
5
k Ventilation outlet
l INPUT SELECT switch
Switches the input signal.
VF: Inputs signals from the VF connector (VF mode).
SDI: Inputs signals from the SDI IN connector (monitor
mode).
qa
qs
m TALLY DIMMER switch
qd
Allows you to adjust the tally indicator's brightness.
qf
Set this to OFF when you are not using the tally indicator.
qg
HIGH: Increases the brightness.
LOW: Decreases the brightness.
qh
OFF: Turns the indicator off.
n FOCUS MAG (magnified display) button
qj
Magnifies the height and width of the image (x2) for
qk
easier focus adjustment. This does not affect the camera's
output signal.
ql
The FOCUS MAG indicator lights during magnified
w;
display.
The display switches between magnified display and
normal display with each press of the button.
o SPARE button
When using the PMW-F5/F55 (version 2.00), this allows
you to switch to false color display. This does not affect
the camera's output signal.
The SPARE indicator lights during false color display.
The display switches between false color display and
normal display with each press of the button.
During VF mode, images are displayed according to the
false color configured on the camera.
During monitor mode, images are displayed in an S-
Log2-compatible format.
During false color display, the PEAKING button is
disabled and the peaking cannot be adjusted.
p VF connector (26-pin rectangular type)
When using VF mode, connect this to the VF connector
on the camera using the supplied VF connection cable.
q POWER switch
Sets the power of the LCD panel to ON or SAVE.