Installation Location Setting (Srk Series Only) - Mitsubishi Heavy Industries SRK20ZJX-S Service Manual

(9) Installation location setting (SRK series only)

When the indoor unit is installed at the end of a room, control the air flow direction so that it is not toward the side walls. If you
set the remote controller installation position, keep it so that the air flow is within the range shown in the following figure.
(a) Setting
1) If the air conditioning unit is running, press the ON/OFF button to stop.
The installation location setting cannot be made while the unit is running.
2) Press the AIR FLOW
AIRFLOW   (LEFT/RIGHT) button together for 5 seconds
or more.
The installation location display illuminates.
3) Setting the air-conditioning installation location.
Press the AIR FLOW
location.
Each time the AIR FLOW
indicator is switched in the order of:
(Center Installation)
4) Press the ON/OFF button.
The air-conditioner's installation location is set.
Press within 60 seconds of setting the installation location (while the installation location setting display illuminates).
Airflow range
(Left End Installation)
(10) Determining the operating mode
The cooling and heating operating modes are the remote controller mode that have been previously determined.
If a mode differing from these is selected after this, the selected mode will appear in the display of the remote controller, but
only the fan will operate.
First operation
Example
Selected Mode Remote Controller Display
1 Cooling Cooling
Heating Heating
2
Note (1) If the display shows heating and the operation is fan, Hot Keep will operate.
Example of operating pattern
Cooling
switch
A unit
ON
Heating
B unit
switch
Operation Operation
 
(UP/DOWN) button and the
 
(LEFT/RIGHT) button and adjust to the desired
  (LEFT/RIGHT) button is pressed, the
(Right End Installation) (Left End Installation)
Operation Selected Mode
Cooling Heating
Heating Cooling
Cooling
Fan
ON
Airflow range
(Center Installation)
Second operation
Remote Controller Display Operation
Heating Fan (1)
• Different mode is
Cooling Fan
Heating
switch Fan
ON
Cooling
Cooling
switch
ON
Operation Operation
14
- -
'10 • SCM-SM-094
Airflow range
(Right End Installation)
Notes
only fan operation.
Heating
Heating
Heating
switch
ON
Note (1) [ ] indicates currect operation.
Operation
,