Integrated Tray Compensator Assembly - Lexmark OPTRA 4069-XXX User Manual

4069-XXX

Integrated Tray Compensator Assembly

1. Remove the paper tray.
2. Remove the left door.
3. Remove the inner EMC shield.
4. Disconnect the compensator motor cable (A) from the engine
board.
5. Place the printer on its side.
6. Locate the integrated tray compensator assembly (B) on the
bottom of the printer and disconnect the compensator arm bias
spring from the frame.
7. Remove the c-clip that rests against the right sideframe from
the autocompensator pivot shaft.
8. Disconnect the compensator sensor cable (C) from the
assembly.
9. Remove the compensator assembly mounting screw (D).
10.Remove the integrated tray compensator assembly.
4-38
Service Manual