Diagnostic Information; Start - Lexmark OPTRA 4069-XXX User Manual

4069-XXX

2. Diagnostic Information

Start

CAUTION: Remove the power cord from the printer or wall outlet
before you connect or disconnect any cable or electronic board or
assembly for personal safety and to prevent damage to the printer.
Use the handholds on the side of the printer. Make sure your fingers
are not under the printer when you lift or set the printer down.
Use the service error code, user status message, user error
message, symptom table, service checks, and diagnostic aids in this
chapter to determine the corrective action necessary to repair a
malfunctioning printer.
Service error codes are indicated by a three-digit error code. If a
service error code is displayed, go to the
.
page 2-2
User status messages provide the user with information on the
current status of the printer. Ready is displayed on the first line of the
display unless Power Saver is invoked, and then Power Saver is
displayed. If a user status message is displayed, go to the
Status Messages" on page 2-12
User error messages are indicated by a two or three-digit error code
that provides the user with information that explains a problem with a
print cartridge, paper jam, option, port, and so on. If a user error
message is displayed, go to the
If your machine completes the
without an error, and you have a symptom, go to the
page 2-24
"Symptom Tables" on page 2-25
appropriate action.
If a service error code appears while you are working on the
machine, go to the
indicated action for that error.
.
"User Error Messages" on page 2-16
"Power-On Self Test (POST)" on
. Locate your symptom and take the
"Service Error Codes" on page 2-2
"Service Error Codes" on
and take the
Diagnostic Information
"User
.
2-1