Cover Open Switch/Cable Service Check - Lexmark OPTRA 4069-XXX User Manual

4069-XXX

Cover Open Switch/Cable Service Check

FRU
1 Toner Cartridge
2 Cover Open Switch/Cable
Assembly
Action
Check the toner cartridge to make
sure it is correctly installed and that
the right and left cartridge tracks are
not loose or broken. Check to make
sure the cover open switch activation
tab on the toner cartridge is not
broken and that the tab correctly
activates the cover open switch
spring.
Check the cover open switch for
proper mechanical operation. If
incorrect, repair as necessary.
Disconnect the cover open switch
cable from J4 at the engine board
and measure the voltage at J4-3. It
measures approximately +5 V dc. If
the voltage is incorrect, replace the
engine board. If the voltage is
correct, check the voltage at J4-1. If
the voltage measures greater than
+1.0 V dc, replace the engine board.
If the voltage is correct, check the
continuity between J4-1 and J4-3 on
the cable. If no change in continuity
occurs as the switch is activated,
replace the cover open switch/cable
assembly. If the continuity changes
as the switch is activated, replace
the engine board.
Note: It is easier to check the
voltages on J4 with the controller
board removed.
Diagnostic Information
2-31