Lexmark Laser Printers Label Manual page 21

If zone coating is not used, we recommend a stripped edge matrix. The stripped edge matrix varies
with the type of face stock, liner, and adhesive materials. Refer to the following table for stripped
edge matrix guidelines. Measurements may vary ±0.5 mm.
Stripped Edge Matrix Guidelines
Total Weight
Face Type
1
Paper 140 - 180 g/m
(Cut Sheet or
Dual Web)
Vinyl 265 - 300 g/m
Polyester Varies
and other face
materials
1
Use a non-oozing adhesive.
2
Must be 1.6 mm (0.0625 in.) in some circumstances. See "Vinyl and Polyester Labels" on page 25.
Using cut sheet labels with adhesive applied to the edge of the sheet will contaminate your printer
and your cartridge and could void your printer and cartridge warranties.
When using pressure sensitive materials without zone coating, choose butt cut labels without any
stringers and with a stripped edge matrix. If a total strip matrix is in the design for the final product,
print before removing the matrix. If the matrix must be removed before printing, round all corners and
make sure adhesive is not exposed.
"Figure 3" on page 22 illustrates a recommended label design for Optra plus printers as well as the
4039, 4029 and 4019 laser printers. The Non-Print Area may vary, depending on the printer model.
Edge Matrix
of Label Removal
2
1.6 mm (0.0625 in.)
1.6 mm (0.0625 in.)
2
3.0 mm (0.125 in.)
2.4 mm (0.094 in.)
3.0 mm (0.125 in.)
2.4 mm (0.094 in.)
Label Design Guidelines
215.9 mm (8.5 in.) at leading edge
279.4 mm (11.0 in.) at driver edge
2
215.9 mm (8.5 in.) at leading edge
279.4 mm (11.0 in.) at driver edge
2
215.9 mm (8.5 in.) at leading edge
279.4 mm (11.0 in.) at driver edge
21
Location of Strip