Table of Contents
Advertisement
Pick Roller Technology
Like the Optra S, the Optra T family of printers uses an auto compensator to pick the media rather
than the corner buckler system used by earlier printer models.
The Optra T trays have two rollers that touch the media in two places (see "Figure 12" on page 111).
Avoid placing deep perforations in these areas since the media may nest, causing multiple sheet
feeds. Perforations that could cause nesting and tenting should fall outside the 0.31 - 0.79 in. area on
the leading edge of the media. (This is different from the 0.50 in. we recommend leaving at the top of
the form for printers with a corner buckler system.) You may want to use micro-perfs to avoid nesting
problems. See "Perforations and Die-Cuts" on page 9 for more information.
0.79 in.
Labels are one of the most difficult print materials for laser printers. A special fuser cleaner should be
used for label applications to optimize feed reliability. Refer to your printer documentation for
information on ordering additional label fuser cleaners.
When printing on labels:
•
Using the printer operator panel, set the Paper Type to Labels in the Paper Menu. For vinyl
and other heavy labels, set the Labels Weight (under the Paper Weight menu) to Heavy, and
set the Labels Texture (under the Paper Texture menu) to Smooth.
•
Do not load labels together with paper or transparencies in the same paper tray. Combining
print materials can cause feeding problems.
0.31 in.
Figure 12. Location of Pick Rollers
Pick Roller Location
1.34 in.
1.93 in.
4.84 in.
5.43 in.
Direction of Feed
Optra T
111
Advertisement
Table of Contents
