12 QUALITY OF CUT
12.9 RIFLING OR TRAMLINING __________________________________________________
NOTE: Arrow indicates direction of travel.
Probable Cause
The reel is damaged or is not worn equally.
Loose, missing or over-torqued bedknife screws
Cut (ground) speed is higher than normal
83
Rifling or tramlining is a pattern of different cutting heights
that gives the grass an appearance like a wave. This
appearance is normally because of heavy contact points
across a reel and bedknife.
Check and adjust the HOC on cutting units to same
height.
Install, replace or tighten the bedknife screws to the
correct torque.
Reduce the cut (ground) speed.
Remedy