Armrest Height Adjustment; Armrest Pivot - Jacobsen LF550-H-T4F Safety, Operation And Maintenance Manual

10.5 ARMREST HEIGHT ADJUSTMENT ____________________________________________

The armrest has four available height settings for the operator.
To adjust armrest height:
1. Stop the engine and remove the key.
2. Remove the armrest hardware from the bracket on
the right side of the seat.
3. Lift or lower the armrest as needed until another set of
holes in the armrest bracket align with the seat
bracket. Assemble the armrest hardware.
4. When you adjust the height, check the wiring harness
connector for a tight connection to the mower
harness.

10.6 ARMREST PIVOT __________________________________________________________

1. Adjust the plunger as required so that the plunger
button stops the armrest at both ends of armrest pivot
slots. The plunger body must not contact the armrest
pivot. Do not use the plunger to increase the pivot
tension.
2. Adjust the clamp hardware to get 2 to 6 lbs. (9 to 26.7
N) of force needed at the visor end of the armrest to
move the armrest. Do not over-tighten the pivot
hardware or leave loose.
ADJUSTMENTS 10
Armrest
Hardware
Armrest
Hardware
Clamp
Hardware
Plunger
68