Cruise Control - Jacobsen LF550-H-T4F Safety, Operation And Maintenance Manual

9.2.4 CRUISE CONTROL ________________________________________________________

To enable or disable the cruise control function, press forward or backward on the joystick until
one of the Cruise Control screens is shown on the LDU. Press the LDU button to toggle
between CRUISE ENABLED and CRUISE DISABLED screens.
9.2.5 TRACTION MODE: _________________________________________________________
To set the traction mode, press forward or backward on the joystick until one of the traction
configuration setting screens is shown on the LDU. Press the LDU button to toggle between
TRACTION MODE ON and TRACTION MODE OFF screens.
When TRACTION MODE ON is selected, the mower will accelerate and decelerate at a
slower rate.
9.2.6 SWITCH STATUS __________________________________________________________
Shows the current switch settings to identify a possible problem with the switch. A status of 0
indicates the switch is in the OFF position. A status of 1 indicates the switch is in the ON
position. Check the wires and operation of any switch that does not show the correct status.
The Switches are broken up into three sets of numbers, with a gap between each set.
The numbers displays the status of these switches:
• Neutral Switch (1=Neutral)
• Reel Level Switch
• Seat Switch
• Backlap Switch
• (Gap)
• Cruise Control Switch
• Parking Brake Switch
• Start Switch (Ignition switch in the Start Position)
• (Gap)
• Mow Switch
• Horn Switch
• Light Switch
9.2.7 REGEN REQUEST _________________________________________________________
Used to start a Parked Regen cycle. See Section 9.11 for instructions.
MAINTENANCE 9
CRUISE
ENABLED
Press LDU
Button
CRUISE
DISABLED
TRACTION MODE
OFF
Press LDU
Button
TRACTION MODE
ON
SWITCH STATUS
0000 000 000
REGEN REQUEST
48