Lexmark 231 User Manual page 123

Understanding printer menus
Menu item
Quiet Mode
Off
On
Run Initial setup
Yes
No
Paper Sizes
U.S.
Metric
Scan to PC Port Range
<port range>
Default Mode
Copy
Fax
Date Format
MM‑DD‑YYYY
DD‑MM‑YYYY
YYYY‑MM‑DD
Time Format
12 hour A.M./P.M.
24 hour clock
Alarms
Alarm Control
Cartridge Alarm
Timeouts
Power Saver
Disabled
1–240
Description
Reduces the amount of noise produced by the printer
Notes:
•
Off is the factory default setting.
•
On configures the printer to produce as little noise as
possible.
Instructs the printer to run the setup wizard
Notes:
•
Yes is the factory default setting.
•
After completing the setup wizard by selecting Done at the
Country select screen, the default setting becomes No.
Specifies the printer factory default measurements. The default
setting is determined by the country selection in the initial setup
wizard.
Specifies a valid port range for printers behind a port blocking
firewall. The valid ports are specified by two sets of numbers
separated by a semicolon.
Note: 9751:12000 is the factory default setting.
Sets the function the printer enters when Go, Content, Darkness,
or any number is pressed on the printer control panel
Note: Copy is the factory default setting
Formats the printer date
Note: MM‑DD‑YYYY is the US factory default setting and
DD‑MM‑YYYY is the international factory default setting.
Formats the printer time
Note: The factory default setting is 12 hour A.M./P.M.
Sets an alarm to sound when the printer requires operator
intervention. Available selections for each alarm type are:
Off
Single
Continuous
Notes:
• Single is the factory default setting for Alarm Control. Single
sounds three quick beeps.
•
Off means no alarm will sound.
•
Continuous repeats three beeps every 10 seconds.
Specifies the number of minutes of inactivity before some systems
begin entering a minimum power state.
Note: 30 minutes is the factory default setting.
123