Installation Instructions; Cleaning Instructions; Dispenser - Cornelius D100 Installation Manual

1. *Locate the dispenser indoors on a level counter top. Unpack the four (4) legs and install them into the
threaded holes provided in the bottom of the unit.
2. Connect the 3/4? IPS (or equal) drain line to the 3/4? threaded drain connections at the lower rear of the
unit. This line must pitch downward to an open drain and must contain no traps or improper drainage
will result.
3. Clean the hopper interior. (see CLEANING INSTRUCTIONS).
4. Connect the power cord to a 120 volt, 60 hertz, 3-wire grounded receptacle. All electrical wiring must con-
form to national and local electrical codes.
*Figure 2 shows the mounting template for those who desire to mount dispensers on a counter.
WARNING: DISCONNECT POWER BEFORE CLEANING! Do not use metal scrapers, sharp
objects or abrasives on the ice storage hopper, top cover and the agitator disk, as damage
may result. Do not use solvents or other cleaning agents, as they may attack the plastic
material.

DISPENSER

1. Clean the ice dispenser interior at least once a month.
2. Lift off the agitator assembly. Wash and rinse them thoroughly.
3. Wash down the inside of the hopper and top cover with a mild detergent solution and rinse thoroughly to
remove all traces of detergent.
4. Replace the agitator.
5. Sanitize the inside of the hopper and agitator with a solution of 1 ounce of household bleach in 2 gallons
of water.
6. Remove ice chute cover as follows:
A. Flex sides outward to disengage lower pins.
B. Lift ice chute cover to disengage upper pins.
C. Lower ice chute cover down out of unit. NOTE: it may be helpful to twist cover slightly.
7. Clean the inside of the ice chute and ice chute cover with a mild detergent solution and rinse thoroughly to
remove all traces of detergent.
8. Reverse steps above to reassemble ice chute.
9. Sanitize as described in Step 5.

INSTALLATION INSTRUCTIONS

CLEANING INSTRUCTIONS

2