Diffuser Plate Adjustment - Travis Industries 564 HO NB GSR2 Installation Manual

Diffuser Plate Adjustment

Certain vent configurations require the diffuser plate to be adjusted (refer to the approved vent
configuration charts for details). Position # 1 is stock (bent). Position # 2 is flattened.
Change the diffuser to position #2 as follows:
1. The diffuser is located above the exhaust restrictor (remove the restrictor if necessary).
2. Remove the diffuser.
3. Bend the round portion of the diffuser so it is flat (position #2).
4. Secure the flattened diffuser plate with the screws removed earlier.
5. Replace the exhaust restrictor. See "Exhaust Restrictor Adjustment" for the restrictor settings.
Travis Industries
Installation
(
2
4
for qualified installers only)
1
1/4" Nutdriver
DIFFUSER SIDE VIEW
3
Before (Stock - Position #1)
After (Position #2)
4150330
25
100-01408