Maintenance - Cornelius C10 Product Manual

®

5. MAINTENANCE

Maintenance to be carried out by a suitably trained person only. Compliance with local Bylaws and
Codes of Practise must be ensured.
The cooler requires occasional checking and cleaning as follows-
1. Check that the water level in the tank is up to the overflow. Remove the inspection/fill cover and
observe the water level.
2. Check that the airflow to the cooler is unimpeded and clean the condenser fins. To clean the fins
– electrically isolate the unit, use a soft bristle brush to clean the condenser fins of dirt, dust etc.
Take care not to damage the fins during cleaning.
At regular intervals to be determined by the user and/or owner of the cooler, check for electrical safety.
If any maintenance/servicing is required, refer to the fault finding chart, wiring diagram and exploded
drawings contained in this manual and always ensure that the following are observed-
When replacing components always use IMI Cornelius approved spare parts. Failure to do so will
invalidate the coolers warranty.
Always electrically isolate the cooler before removing covers or carrying out any work.
After working on the cooler ensure that the unit is left electrically safe and that all covers and cover
fixings are refitted.
If replacing a condenser fan motor always fit a new fan blade.
The drier must be replaced each time the refrigeration system is opened.
Always replace seals, screws covers etc. after servicing the cooler.
4
C10/C20 Manual