Install The Battery - HP Photosmart R817 User Manual

Ofrecido por www.electromanuales.com

3. Install the Battery

Your camera uses a rechargeable HP Photosmart R07 Lithium
Ion battery (L1812A/L1812B).
1. Open the Battery/
Memory card door on
the bottom of the
camera by sliding the
door latch as indicated
on the Battery/Memory
card door.
2. Insert the battery in the
larger slot as shown, and push the battery in until the
latch catches.
3. Close the Battery/Memory card by pushing the door
down until it snaps into place.
To remove the battery from the camera, first turn the camera
off. Open the Battery/Memory card door and release the
battery latch to allow the battery to be partially ejected, then
pull the battery from the slot.
See page 171 for information about battery performance
with this camera. For the number of shots expected for each
battery based on usage, see page 172. For hints on
optimizing battery performance, see Appendix A, Managing
Batteries, starting on page167.
NOTE: The rechargeable battery that was shipped with your
camera may be partially charged. You should fully
charge it before using it the first time (see page 15).
14 HP Photosmart R817/R818 User's Manual