Lexmark 7300 series Service Manual page 25

Code Name
1212 Watchdog Error
1213 Data Abort
Error
1214 Invalid
Processor
Mode Error
1215 Math Error
1216 Mailbox Error
1217 Temperature
Error
Description
Indicates printer
system was reset by
Watchdog timer;
Subsystem stall failure.
Firmware attempted to
load or store to an
invalid address.
The ARM processor
was in an incorrect
mode to perform the
requested operation.
There is a problem
doing math, such as
dividing by zero.
There is a problem
with the internal
mailbox messaging
system.
There is a problem
determining
temperature.
Action
Unplug the
All-In-One; wait five
minutes, then plug
the All-In-One back
in, and turn the power
on. If the error
remains, replace the
system board.
Unplug the
All-In-One; wait a few
seconds, then plug
the All-In-One back
in, and turn the power
on. If the error
remains, replace the
system board.
Unplug the
All-In-One; wait a few
seconds, then plug
the All-In-One back
in, and turn the power
on. If the error
remains, replace the
system board.
Unplug the
All-In-One; wait a few
seconds, then plug
the All-In-One back
in, and turn the power
on. If the error
remains, replace the
system board.
Unplug the
All-In-One; wait a few
seconds, then plug
the All-In-One back
in, and turn the power
on. If the error
remains, replace the
system board.
Replace the print
cartridge.
Diagnostic information
4418-X6X
2-5