Connect Electric Power - Chamberlain LM650EVGB Installation And Operating Instructions Manual

12
INSTALLATION PROCEDURE)
Do not allow people to walk under or
around the door during the installation
process as serious injury can occur.
NOTE: The opener can be installed on either side
of the door. The following instructions are for
RIGHT HAND INSTALLATIONS (as illustrated i.e.
inside the garage looking out). For left hand
installations, reverse the instruction terminology
(eg LEFT for RIGHT etc).
Preparation:
• Place the opener in manual release mode (refer section 8).
• Open the roller door fully. For safety, tie a rope around
the door.
• Ensure the door axle U-BOLT and door mounting bracket
on the left hand side (non opener side) are securely fastened.
• Support the door with a door stand or similar device to safely
support the door.
• Mark the position of the door shaft on the right hand door
bracket (for reassembly purposes).
• While the door is supported, remove the right hand axle
U-Bolt and door mounting bracket from the wall.
Install the opener:
• Slide the opener over the door axle and engage the drive
legs into the door drum wheel, either side of a spoke.
Extensions may be necessary (refer section 10).
• Refit the door mounting bracket to the wall. If the door bracket
needs to be relocated due to opener width, refer section 3.
• Clamp the opener on the door axle and door bracket in the
marked position using the clamp assembly supplied
(tighten to 25 – 28 Nm).
• If side room exceeds 95mm clamp independently to the door
axle as illustrated in section 3.
• Remove all ropes and the support stand.
• Check the operation of the door in manual mode by raising
and lowering by hand. It should operate smoothly without
sticking or binding. The disengage handle should already
be attached less than 1.8m
above the floor (refer section 7).
Connect the power:
• Position the power cable away from the door curtain
and any moving parts.
• Plug the opener into a nearby power point and turn ON.
• The opener courtesy LEDs should turn ON.
• The opener must now be programmed for:-
• DOOR TRAVEL LIMITS (Section 13)
• RIGHT OR LEFT HAND OPERATION (Section 13)
• FORCE SETTING (Section 14)
Rope
Door stand
Rope
Door stand
Tighten to
25-28 Nm
6