Wireless Programming - Chamberlain LM650EVGB Installation And Operating Instructions Manual

17
INSTALLING YOUR WIRELESS WALL BUTTON
Disconnect power to the opener whilst installing
this accessory to prevent accidental activation.
Locate minimum 1.5 m above the floor
To install:
• Carefully pry open the device and locate the two screws for
mounting.
• Attach to the wall using the two screws and wall anchors
provided if mounting to a plaster wall. If using a recessed wall
box do not use anchors.
NOTE: Do not overtighten screws.
NOTE: The wall control supplied with your opener should be
pre-programmed by the factory.
If adding a new wall control, program into the opener before
mounting the unit as detailed in section 18.
18
WIRELESS PROGRAMING (OPTIONAL ACCESSORIES)
NOTE: Transmitter(s) and wall button supplied with your opener are factory programmed.
Activate the opener only when the door is in full view, free of obstruction and properly adjusted.
No one should enter or leave garage whilst the door is in motion. Do not allow children to operate
push button(s) or transmitter(s). Do not allow children to play near the door.
Fix any wall control at a height of at least 1.5 m and within sight of the door but away from any
moving parts.
NOTE: If adding an installed wall control
you will need a second person to press and hold
the desired button. If not installed, program the
wall button into the opener before mounting.
ADDING transmitters using the LRN "LEARN"
button
• Press and hold down the button you wish to program
to the opener.
• The orange LED on the opener will flash to indicate
it is receiving signal from the transmitter.
• Press and release the "LRN" button.
• The courtesy LEDs will flash once.
• Ensure the door is clear of obstruction, then test the
transmitter.
Deleting ALL transmitter codes
NOTE: This deletes all transmitters and codes
• Press and hold the LRN learn button until the orange
indicator light goes out (approximately 9 sec).
3
2
2
.
3
T O ADD Trans mitters / Wireles s wall button
P res s and hold down the des ired
B utton.
L E D will F L AS H
or
Press LEARN
R eleas e L R N button when
C ourtes y L E Ds
flas hes onc e
T O DE L E T E AL L R E M OT E S
P res s L E AR N for 9 s ec onds
L E D on WIL L T UR N ON
After 9 s ec onds all remotes
are deleted and L E D will go
out.
10