WARNING Start by Reading These Important Safety Instructions Failure to comply with the following instructions may result in serious personal injury or property damage. • Read these instructions carefully • The garage door opener is designed and tested to offer reasonable safe service provided it is installed and operated in strict accordance with the instructions in this manual.
Install the Chain/Belt Before You Begin 1. Look at the wall or ceiling above the garage door. The header Remove chain/belt from carton and lay chain out on floor (do not allow bracket must be securely fastened to structural supports. chain/belt to twist).
Page 4
Attach Emergency Release Rope & Handle Position the Header Bracket Thread one end of rope (1) through hole in top of red handle so The header bracket must be rigidly fastened to a structural "NOTICE" reads right side up as shown (3). Secure with an overhand support of the garage.
Install Door Control Program your Opener & Remote/Wireless Wall Control Locate door control where the garage door is visible, away from door and door hardware and out of the reach of children. Mount Activate the opener only when door is in full view, free of at least 1,5 m (5 feet) above the floor obstruction and properly adjusted.
ADJUSTMENT SECTION Program your Keyless Entry Activate the opener only when door is in full view, free of Setting the Limits obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Do not allow children to operate Travel limits regulate the points at which the door will stop when push button(s) or remote(s).
HAVING A PROBLEM? Install the Protector System ™ 1. Opener doesn't operate from either door control or remote: (See accessories) The force, as measured on the closing edge of the door, should • Does the opener have electric power? Plug lamp into outlet. If it not exceed 400 N (40kg).
HAVING A PROBLEM? (CONT.) CARE OF YOUR OPENER When properly installed, opener will provide high performance with a minimum of maintenance. The opener does not require additional 12. Opener strains: lubrication. Door may be unbalanced or springs are broken. Close door and use Limit and Force Settings: These settings must be checked and manual release rope and handle to disconnect trolley.
OPERATION OF YOUR OPENER SPECIFICATIONS Your opener can be activated by any of the following devices: Input Voltage....230-240 VAC, 50Hz • The Lighted Door Control Button. Hold the button down until door Max. Pull Force ....600N (LM60), 800N (LM80) starts to move. Power ......100W (LM60), 125W (LM80) •...