Connect Electric Power - Chamberlain Merlin Professional MR1000 Installation And Operating Instructions Manual

12
INSTALLATION PROCEDURE
Do not allow people to walk under or around
the door during the installation process.
Serious injury can occur.
NOTE: The opener can be installed on either side
of the door. The following instructions are for
RIGHT HAND INSTALLATIONS (as illustrated i.e.
inside the garage looking out). For left hand
installations, reverse the instruction terminology
(eg LEFT for RIGHT etc).
Preparation:
• Place the opener in manual release mode (refer
section 8).
• Open the roller door fully. For safety, tie a rope
around the door.
• Ensure the door axle U-bolt and door mounting
bracket on the left hand side (non opener side) are
securely fastened.
• Support the door with a door stand or similar device
to safely support the door.
• Mark the position of the door axle on the right hand
door bracket (for reassembly purposes).
• While the door is supported, remove the right hand
axle U-Bolt and door mounting bracket from the wall.
Install the opener:
• Slide the opener over the door axle and engage the
drive forks into the door drum wheel, either side of a
support spoke.
• Refit the door mounting bracket to the wall and the
U-bolt to the axle. If the door bracket needs to be
relocated due to opener width, the dimensions in
section 3 can assist.
• Position the opener assembly vertical to the floor.
• Clamp the opener on the door axle using the cone
tipped hex bolts supplied in the mounting collar.
• Remove all ropes and the support stand.
Ensure that mounting bolts are adequately
tightened (i.e. 25– 28Nm) to avoid any
movement on the door axle.
• Check the operation of the door in manual mode by
raising and lowering by hand. It should operate
smoothly with no obstructions. The disengage
handle should already be attached less than 1.8m
above the floor gap.
Connect the power
• Position the power cable away from the door curtain
and any moving parts.
• Plug the opener into a nearby power point and turn
ON (opener courtesy lamp should turn ON).
• The opener must now be programmed for:-
Door travel limits
Force setting
(section 13)
(section 14)
7
Rope
Door Stand
Rope
Door Stand