Wireless Programming - Chamberlain RollerLift CR655MYQ Installation And Operating Instructions Manual

20
WIRELESS PROGRAMMING (REMOTE ACCESSORIES)
NOTE: The transmitters supplied with your opener are preprogrammed by the factory.
Activate the opener only when door is in full view, free of obstruction and properly adjusted.
No one should enter or leave the garage while the door is in motion. Do not allow children to
operate push buttons or remotes. Do not allow children to play near the door.
If you purchase additional transmitters, the garage
door opener must be programmed to accept the new
transmitter code.
Program the receiver to match additional
transmitter codes:
Using the "S" SAVE Button
1.Press and hold the button on the transmitter that you
wish to use (1).
2.Press and release the "S" button on the opener (2).
3.Release the transmitter when the courtesy light
flashes twice. It has learnt the code. If you release
the transmitter button before the opener light flashes,
the opener has not learnt the code.
The opener will now operate when the transmitter
button is pressed.
To Erase all Transmitter Codes
1.Press and hold the "S" button on the opener until the courtesy light flashes twice, and continue
holding for approximately 8 seconds, until the courtesy light flashes twice again.
2.Release the button, all codes are now erased.
2
DN
12
1
Flash
x 2
1 3
S
2
P
UP