Repair Procedures; Procedure 1: Calibrating The Unit - Spirit XT 8 Service Manual

Hide thumbs Also See for XT 8:

Owner's manual (27 pages)

Table Of Contents

Table of Contents

PROCEDURE 1: Calibrating the unit

1. Remove tether cord. Press and hold the START and FAST buttons and put tether cord back on. Display will go

into test mode. "SET" will blink in middle of screen.

2. Use "STOP" button to change from Km (Meteric) to M (English).

3. Wheel size will be shown in the SPEED window. Use FAST or SLOW buttons to change. (2.50) Press START.

4. Minimum speed will be shown in the SPEED window. Use FAST or SLOW buttons to change. (0.5) Press

START.

5. Max speed will be shown in the SPEED window. Use FAST or SLOW buttons to change. (10.0) Max elevation

will be shown in the INCLINE window. Use UP or DOWN buttons to change. (14)

6. Press START. Unit will now auto-calibrate speed then incline. Unit will reset when it completes calibration.

1. Remove tether cord. Press and hold the START and FAST buttons and put tether cord back on. Display will go

into test mode. Press ENTER.

2. "UNITS" English or Metric will scroll along the bottom of the display. Use UP or DOWN buttons to change.

Press ENTER.

3. "ADJUST WHEEL SIZE" will scroll along the bottom of the display and a number will flash in the calorie

window. Use UP or DOWN buttons to change. (2.30) Press ENTER.

4. "ADJUST MIN SPEED" will scroll along the bottom of the display and a number will flash in the calorie

window. Use UP or DOWN buttons to change. (0.5) Press ENTER.

5. "ADJUST MAX SPEED" will scroll along the bottom of the display and a number will flash in the calorie

window. Use UP or DOWN buttons to change. (10.0) Press ENTER.

6. "ADJUST MAX ELEVATION" will scroll along the bottom of the display and a number will be in the calorie

window. Use UP or DOWN buttons to change. (14) Press ENTER.

7. "GRADE RETURN" will scroll along the bottom of the display and "ON" or "OFF" will be in the calorie

window. Use UP or DOWN to change. (ON)

8. Press START. Unit will now auto-calibrate speed then incline. Unit will reset when it completes calibration.

1. Remove tether cord. Press and hold the START and FAST buttons and put the tether cord back on. Display will

go into a test mode then FACTORY SETTING will scroll across the screen. Press ENTER.

2. "POWER ON" will scroll across the screen. Use UP or DOWN buttons to change. (ON) Press ENTER.

3. "UNITS ENGLISH" will scroll across the screen. Use UP or DOWN buttons to change from English to Metric.

Press ENTER.

4. "ADJUST WHEEL SIZE" will scroll across the screen. A number will be in the time window. Use UP or DOWN

buttons to change. (2.50) Press ENTER.

5. "ADJUST MIN SPEED" will scroll across the screen. A number will be in the time window. Use UP or DOWN

buttons to change. (0.5) Press ENTER.

6. "ADJUST MAX SPEED" will scroll across the screen. A number will be in the time window. Use UP or DOWN

buttons to change. (12.0) Press ENTER.

7. "ADJUST MAX ELEVATION" will scroll across the screen. A number will be in the time window. Use UP or

DOWN buttons to change. (15)

8. Press START. Unit will now auto-calibrate speed then incline. Unit will reset when it completes calibration.