Replacing The Cover And Connecting The Cables - IBM A50 User Manual

10. Replace the cover and connect the power cord. See "Replacing the cover and

Replacing the cover and connecting the cables

After working with options, you need to install any removed parts, replace the
cover, and reconnect any cables, including telephone lines and power cords. Also,
depending on the option that is installed, you might need to confirm the updated
information in the IBM Setup Utility program.
To replace the cover and connect cables to your computer:
1. Ensure that all components have been reassembled correctly and that no tools
2. Clear any cables that might impede the replacement of the cover.
3. Position the cover on the chassis so that the guides on the top and bottom of
4. Reconnect the external cables and power cords to the computer. See "Installing
48
User Guide
4. If necessary, see "Installing adapters" on page 38 to remove any adapters that
impede access to the Clear CMOS/Recovery jumper.
5. Move the jumper from the standard position (pins 1 and 2) to the
maintenance or configure position (pins 2 and 3).
6. Replace the cover and connect the power cord. See "Replacing the cover and
connecting the cables."
7. Restart the computer, leave it on for approximately 10 seconds. Turn off the
computer by holding the power switch for approximately 5 seconds. The
computer will turn off.
8. Repeat steps 2 through 4 on page 47..
9. Move the jumper back to the standard (pins 1 and 2).
connecting the cables."
or loose screws are left inside your computer.
the cover engage the chassis and push the cover to the closed position. Insert
the screws that secure the cover.
external options" on page 30.