Erasing A Lost Or Forgotten Password (Clearing Cmos) - IBM A50 User Manual

Refer to "Lithium battery notice" on page x for information about replacing and
disposing of the battery.
To change the battery:
10. Use the IBM Setup Utility program to set the date and time and any

Erasing a lost or forgotten password (clearing CMOS)

This section applies to lost or forgotten passwords. For more information about
lost or forgotten passwords, see Access IBM on your desktop.
To erase a forgotten password:
22
User Guide
1. Turn off the computer and all attached devices.
2. Remove the cover. See "Removing the cover" on page 9.
3. Locate the battery. See "Identifying parts on the system board" on page 10.
4. If necessary, remove any adapters that impede access to the battery. See
"Installing adapters" on page 12 for more information.
5. Remove the old battery.
6. Install the new battery.
7. Replace any adapters that were removed to gain access to the battery. See
"Installing adapters" on page 12 for instructions for replacing adapters.
8. Replace the cover, and plug in the power cord. See "Replacing the cover and
connecting the cables" on page 23.
Note: When the computer is turned on for the first time after battery
replacement, an error message might be displayed. This is normal after
replacing the battery.
9. Turn on the computer and all attached devices.
passwords. See Chapter 4, "Using the IBM Setup Utility program," on page 77.
1. Turn off the computer and all attached devices.
2. Remove the cover. See "Removing the cover" on page 9.
3. Locate the Clear CMOS/Recovery jumper on the system board. See
"Identifying parts on the system board" on page 10.
4. If necessary, see "Installing adapters" on page 12 to remove any adapters that
impede access to the Clear CMOS/Recovery jumper.
5. Move the jumper from the standard position (pins 1 and 2) to the
maintenance or configure position (pins 2 and 3).